5" ID Wall Eye Wall Port - Fits Wall Thickness of 4 1/2" - 7 1/2" Sewing The unit installs in a

The unit installs in a recommended 4 3/8" diameter hole

both when in use and when not it use

The elbow is designed to facilitate a drip loop for cables that pass through an exterior wall

from side of a barrier to the other through a aesthetically pleasing port

This little bit of clearance on the units OD allows for a much smoother process when installing the unit with regards to alignment

5" ID Wall Eye Wall Port - Fits Wall Thickness of 4 1/2" - 7 1/2" Sewing The unit installs in aThis 5" ID Wall Eye Wall Port will allow the user to install a fully dressed port in a wall or other barrier that has a thickness range from 4 1 2" thick up to 7 1 2" thick. This is a port that runs from one side of a wall to the other, all the way through the wall. It does not allow access to the interior of the wall stud area. This unit has a 6" OD on the tube that goes through the wall so a 6 1 8" 6 1 4" hole would be recommended for installation.